Serving a Nix store via SSH

You can tell Lix to automatically fetch needed binaries from a remote Nix store via SSH. For example, the following installs Firefox, automatically fetching any store paths in Firefox’s closure if they are available on the server avalon:

$ nix-env --install --attr nixpkgs.firefox --substituters ssh://alice@avalon

This works similar to the binary cache substituter that Lix usually uses, only using SSH instead of HTTP: if a store path P is needed, Lix will first check if it’s available in the Nix store on avalon. If not, it will fall back to using the binary cache substituter, and then to building from source.

Note

The SSH substituter currently does not allow you to enter an SSH passphrase interactively. Therefore, you should use ssh-add to load the decrypted private key into ssh-agent.

You can also copy the closure of some store path, without installing it into your profile, e.g.

$ nix-store --realise /nix/store/m85bxg…-firefox-34.0.5 --substituters
ssh://alice@avalon

This is essentially equivalent to doing

$ nix-copy-closure --from alice@avalon
/nix/store/m85bxg…-firefox-34.0.5

You can use SSH’s forced command feature to set up a restricted user account for SSH substituter access, allowing read-only access to the local Nix store, but nothing more. For example, add the following lines to sshd_config to restrict the user nix-ssh:

Match User nix-ssh
  AllowAgentForwarding no
  AllowTcpForwarding no
  PermitTTY no
  PermitTunnel no
  X11Forwarding no
  ForceCommand nix-store --serve
Match All

On NixOS, you can accomplish the same by adding the following to your configuration.nix:

nix.sshServe.enable = true;
nix.sshServe.keys = [ "ssh-dss AAAAB3NzaC1k... bob@example.org" ];

where the latter line lists the public keys of users that are allowed to connect.